产品类别

  • 车位锁
  • 卷帘门
  • 灭火器材
  • 遥控车位锁
  • 交通安全标志
  • 联系我们
    电话:0518-534376
    邮箱:ceutwas@prettywomanfashions.com
    新闻详情

    工业卷帘门卷轴不转的原因

    工业卷帘门卷轴不转的原因

    工业卷帘门卷轴不转的原因?

    Industrial shutter scroll not turn?

    Answer: the hook piece off or broken, need to be fixed, the reason is the motor run limit the repair is fairly simple.

    Q: curtain plate electric fireproof rolling shutter door from the shaft down, how to put up, I saw shaft has a few small curtain plate fixed on the reel bolt?

    (补充:是停电的时候用手动关门的,可能是放过头了,轴上的那些小帘板每个有十公分长,大约有五个,应该是用来连接下来的帘板的,就是不知道怎么连起来了,电机是好的,现在整个门就处于关闭状态,求专业有经验人士帮助,分全给)

    (added: when blackout manual closing, may be the small panels each discharge head, shaft is ten centimeters long, about five, should be the curtain plate used to connect down, just don't know how to connect, the motor is good, now the door in closed, please experienced people help, points to)

    答:首先把卷轴再放在墙的两侧的固定托板上、把轴上的螺丝卸下了,把那几块小的帘片固定在卷帘上、然后把卷帘吊到卷轴上,把那几块小的帘片上面有孔和卷轴上的孔对正用螺丝固定好、用电机把卷帘卷到一定位置,调试电机的行程,调试好了即可。

    Answer: first of all, the fixed plate roll on both sides of the wall of the shaft, screw off, put the pieces curtain sheet is fixed on the shutter, and then the curtain hanging onto the scroll, the little curtain sheet above the hole and the hole on the fixed scroll the screw motor, with the rolling roll to a certain position, debugging of motor trip, good debugging.

    Answer: Is it right? Program is doing this? There is no fire alarm control panel and the connection, if the connection, Is it right? Control panel made up of instruction?

    BACK

    版权所有江苏省信春车位锁有限公司, All rights reserved.